Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 159
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
4. Example:
The following example enables the vlan VLANID (2) and name VLAN_NAME
(vlan2) of bridge GROUP (1):
switch_a(config-vlan)#vlan 2 bridge 1 name vlan2 state enable
switch_a(config-vlan)#
802.1Q Port Setting
Switchport mode access:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use switchport mode access command to set the switching characteristics of the
Layer-2 interface to access mode, and classify untagged frames only.
Use the no switchport access command to reset the mode of the Layer-2 interface
to access (default).
3. Command Syntax:
switchport mode access
no switchport access
4. Example:
The following example sets the switchport mode access of the interface fe1 (port
1):
switch_a(config)#interface fe1
switch_a(config-if)#switchport mode access
switch_a(config-if)#
Switchport mode hybrid: