Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 140
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Use static-channel-group command to create a static aggregator, or add a
member port to an already-existing static aggregator.
Use the no static-channel-group command to detach the port from the static
aggregator.
3. Command Syntax:
static-channel-group <1-3>
no static-channel-group
<1-3> Channel group number.
Maximum 4 ports in static-channel-group 1 and static-channel-group 2.
Maximum 2 ports in static-channel-group 3
4. Example:
The following example adding the interface fe1 (port 1) to static-channel-group 1:
switch_a(config)#interface fe1
switch_a(config-if)#static-channel-group 1
switch_a(config-if)#
6.6 STP/Ring
Global Configuration, RSTP Port Setting, MSTP Properties, MSTP Instance Setting,
MSTP Port Setting, Ring Setting
Global Configuration
STP Version:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to choose the Spanning Tree protocol, Rapid Spanning Tree
protocol, or Multiple Spanning Tree protocol on a bridge.