Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 158
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Use vlan database command to enter the VLAN configuration mode.
3. Command Syntax:
vlan database
4. Example:
The following example changes to VLAN configuration mode from Configure
mode:
switch_a(config)#vlan database
switch_a(config-vlan)#
Add VLAN/Delete VLAN:
1. Command Mode: VLAN Configure mode
Logon to Configure Mode (Configure Terminal Mode). Logon to VLAN Configure
Mode. The switch_a(config-vlan)# prompt will show on the screen.
switch_a(config)#vlan database
switch_a(config-vlan)#
2. Usage:
This command enables or disables the state of a particular VLAN on a bridge
basis. Specifying the disable state causes all forwarding over the specified VLAN
ID on the specified bridge to cease. Specifying the enable state allows forwarding
of frames on the specified VLAN-aware bridge.
3. Command Syntax:
vlan VLANID bridge GROUP name VLAN_NAME state enable/disable
no vlan VLANID bridge GROUP
VLANID The VID of the VLAN that will be enabled or disabled on the bridge
<2-4094>.
GROUP <1-1> The ID of the bridge-group on which the VLAN will be affected.
VLAN_NAME The ASCII name of the VLAN. Maximum length: 16 characters.
enable Sets VLAN into an enable state.
disable Sets VLAN into a disable state.