Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 167
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Use wrr-queue bandwidth command to specify the bandwidth ratios of the
transmit queues.
3. Command Syntax:
wrr-queue bandwidth WRR_WTS
WRR_WTS Weighted Round Robin (WRR) weights for the 4 queues (4 values
separated by spaces). Range is 1–55.
4. Example:
The following example specifies the bandwidth ratios of the transmit queues on
the Hardened Ethernet Extender Switch:
switch_a(config)#wrr-queue bandwidth 1 2 4 8
switch_a(config)#
802.1p Priority
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode). The switch_a(config)#
prompt will show on the screen.
switch_a(config)#
2. Usage:
Use wrr-queue cos-map command to specify CoS values for a queue.
3. Command Syntax:
wrr-queue cos-map QUEUE_ID COS_VALUE
QUEUE_ID Queue ID. Range is 0-3.
COS_VALUE CoS values. Up to 8 values (separated by spaces). Range is 0-7.
4. Example:
The following example shows mapping CoS values 0 and 1 to queue 1 on the
Hardened Ethernet Extender Switch:
switch_a(config)#wrr-queue cos-map 1 0 1
switch_a(config)#
DSCP