Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 177
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
Use no dot1x system-auth-ctrl command to globally disable authentication.
3. Command Syntax:
(no) dot1x system-auth-ctrl
4. Example:
The following example globally enables authentication:
switch_a(config)#dot1x system-auth-ctrl
switch_a(config)#
Radius Server IP:
Radius Server Port:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify the IP address of the remote radius server host and
assign authentication and accounting destination port number.
3. Command Syntax:
(no) radius-server host IP-ADDRESS auth-port PORT
IP-ADDRESS A.B.C.D specifies the IP address of the radius server host.
PORT specifies the UDP destination port for authentication requests. The host is
not used for authentication if set to 0.
4. Example:
The following example specifies the IP address (192.168.1.100) of the remote
radius server host and assigns authentication and accounting destination port
number (1812):
switch_a(config)#radius-server host 192.168.1.100 auth-port 1812