Black Box 8-port 10/100base-tx hardened ethernet extender switch Network Hardware User Manual


 
Page 181
724-746-5500 | blackbox.com
LB308A
Chapter 6: Command Line Console Management
2. Usage:
Use this command to force a port state.
Use no dot1x port-control command to remove a port from the 802.1x
management.
3. Command Syntax:
dot1x port-control auto|force-authorized|force-unauthorized
no dot1x port-control
auto Specify to enable authentication on port.
force-authorized Specify to force a port to always be in an authorized state.
force-unauthorized Specify to force a port to always be in an unauthorized state.
4. Example:
The following example specifies to enable authetication on the interface fe1 (port
1):
switch_a(config)#interface fe1
switch_a(config-if)#dot1x port-control auto
switch_a(config-if)#
Periodic Reauthentication:
Reauthentication Period:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode). Then logon to Interface
mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set the interval between reauthorization attempts.
Use no dot1x timeout re-authperiod command to delete the interval between
reauthorization attempts.