Dell 1355 Printer User Manual


 
192 Print Media Guidelines
Do not mix print media sizes, weights, or types in the same source. This
may result in a paper jam.
Do not remove the PSI while a job is printing.
Ensure that the paper is properly loaded in the MPF or PSI.
Flex paper back and forth, and then fan them. Straighten the edges of the
stack on a level surface.
Selecting Preprinted Media and Letterhead
When selecting preprinted media and letterhead paper for the printer:
Use grain long paper for best results.
Use only forms and letterhead printed using an offset lithographic or
engraved printing process.
Select paper that absorb ink, but do not bleed.
Avoid paper with rough or heavily textured surfaces.
Use paper printed with heat-resistant inks designed for use in xerographic
copiers. The ink must withstand temperatures of 225°C (437°F) without
melting or releasing hazardous emissions.
Use inks that are not affected by the resin in toner or the silicone in the
fuser. Inks that are oxidation-set or oil-based should meet these
requirements; latex inks might not. If you are in doubt, contact your paper
supplier.
Printing on Letterhead
Check with the manufacturer or vendor to determine whether the pre-printed
letterhead you have selected is acceptable for laser printers.