Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
116
config gvrp
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
by the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
Restrictions User Account Command Level – Administrator and Operator.
Example usage:
To set the ingress checking status, the sending and receiving GVRP information:
DES-3526:admin#config gvrp 1-4 state enable
ingress_checking enable acceptable_frame tagged_only pvid
2
Command: config gvrp 1-4 state enable ingress_checking
enable acceptable_frame tagged_only pvid 2
Success.
DES-3526:admin#
enable gvrp
Purpose Used to enable GVRP on the Switch.
Syntax
enable gvrp
Description
This command, along with disable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP configuration
on the Switch.
Parameters None.
Restrictions User Account Command Level – Administrator and Operator.
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3526:admin#enable gvrp
Command: enable gvrp
Success.
DES-3526:admin#
disable gvrp
Purpose Used to disable GVRP on the Switch.
Syntax
disable gvrp
Description
This command, along with enable gvrp, is used to enable and
disable GVRP on the Switch, without changing the GVRP
configuration on the Switch.
Parameters None.
Restrictions User Account Command Level – Administrator and Operator.