Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
175
DES-3526:admin#show 802.1x auth_state
Command: show 802.1x auth_state
Port number : 1:1
Index MAC Address Auth PAE State Backend State Port Status
------ --------------- ------------------ ---------------- -------------
1 00-08-02-4E-DA-FA Authenticated Idle
Authorized
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description
The config 802.1x authentication mode command is used to
enable either the port-based or MAC-based 802.1x authentication
feature on the Switch.
Parameters
[port_based | mac_based ports] − The Switch allows users to
authenticate 802.1x by either port or MAC address.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To configure 802.1x authentication by MAC address:
DES-3526:admin#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DES-3526:admin#
config 802.1x capability ports
Purpose Used to configure the 802.1x capability of a range of ports on the
Switch.
Syntax
config 802.1x capability ports [<portlist> | all] [authenticator |
none]
Description
The config 802.1x command has four capabilities that can be set for
each port. Authenticator, Supplicant, Authenticator and Supplicant,
and None.
Parameters
<portlist> − Specifies a port or range of ports to be configured.