Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
219
config dst
disable - Disable the DST seasonal time adjustment for the Switch.
repeating - Using repeating mode will enable DST seasonal time adjustment.
Repeating mode requires that the DST beginning and ending date be
specified using a formula. For example, specify to begin DST on Saturday
during the second week of April and end DST on Sunday during the last
week of October.
annual - Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
October 14.
s_week - Configure the week of the month in which DST begins.
• <start_week 1-4,last> - The number of the week during the month
in which DST begins where 1 is the first week, 2 is the second
week and so on, last is the last week of the month.
e_week - Configure the week of the month in which DST ends.
Parameters
• <end_week 1-4,last> - The number of the week during the month in
which DST ends where 1 is the first week, 2 is the second week
and so on, last is the last week of the month.
s_day – Configure the day of the week in which DST begins.
• <start_day sun-sat> - The day of the week in which DST begins
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat)
e_day - Configure the day of the week in which DST ends.
• <end_day sun-sat> - The day of the week in which DST ends
expressed using a three character abbreviation (sun, mon, tue,
wed, thu, fri, sat)
s_mth - Configure the month in which DST begins.
• <start_mth 1-12> - The month to begin DST expressed as a
number.
e_mth - Configure the month in which DST ends.
• <end_mth 1-12> - The month to end DST expressed as a number.
s_time – Configure the time of day to begin DST.
• <start_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
e_time - Configure the time of day to end DST.
• <end_time hh:mm> - Time is expressed using a 24-hour clock, in
hours and minutes.
s_date - Configure the specific date (day of the month) to begin DST.
• <start_date 1-31> - The start date is expressed numerically.
e_date - Configure the specific date (day of the month) to begin DST.
• <end_date 1-31> - The end date is expressed numerically.
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to subtract
during the summertime. The possible offset times are 30,60,90,120. The
default value is 60
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch: