Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
124
DES-3526:admin#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Type : TRUNK
Master Port : 5
Member Port : 5-7,9
Active Port :
Status : Disabled
Flooding Port : X
DES-3526:admin#
config lacp_ports
Purpose Used to configure settings for LACP compliant ports.
Syntax
config lacp_ports <portlist> mode [active | passive]
Description This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
Parameters
<portlist> − Specifies a port or range of ports to be configured.
mode – Select the mode to determine if LACP ports will process
LACP control frames.
• active – Active LACP ports are capable of processing and
sending LACP control frames. This allows LACP compliant
devices to negotiate the aggregated link so the group may
be changed dynamically as needs require. In order to utilize
the ability to change an aggregated port group, that is, to
add or subtract ports from the group, at least one of the
participating devices must designate LACP ports as active.
Both devices must support LACP.
• passive – LACP ports that are designated as passive
cannot process LACP control frames. In order to allow the
linked port group to negotiate adjustments and make
changes dynamically, at one end of the connection must
have “active” LACP ports (see above).
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure LACP port mode settings:
DES-3526:admin#config lacp_port 1-12 mode active
Command: config lacp_port 1-12 mode active
Success.
DES-3526:admin#