Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
181
show radius
Restrictions None.
Example usage:
To display RADIUS settings on the Switch:
DES-3526:admin#show radius
Command: show radius
Index IP Address Auth-Port Acct-Port Status Key
Number Number
----- ------------- --------- --------- ----------- ---------
1 10.1.1.1 1812 1813 Active switch
2 20.1.1.1 1800 1813 Active des3226
3 30.1.1.1 1812 1813 Active dlink
Total Entries : 3
DES-3526:admin#
create 802.1x guest_vlan
Purpose Used to configure a pre-existing VLAN as a 802.1x Guest VLAN.
Syntax
create 802.1x guest_vlan <vlan_name 32>
Description
The create 802.1x guest_vlan command is used to configure a pre-
defined VLAN as a 802.1x Guest VLAN. Guest 802.1X VLAN clients
are those who have not been authorized for 802.1x or they haven’t
yet installed the necessary 802.1x software, yet would still like
limited access rights on the Switch.
Parameters
<vlan_name 32> - Enter an alphanumeric string of no more than 32
characters to define a pre-existing VLAN as a 802.1x Guest VLAN.
This VLAN must have first been created with the create vlan
command mentioned earlier in this manual.
Restrictions User Account Command Level – Administrator and Operator
This VLAN is only supported for port-based 802.1x and must have
already been previously created using the create vlan command.
Only one VLAN can be set as the 802.1x Guest VLAN.
Example usage:
To configure a previously created VLAN as a 802.1x Guest VLAN for the Switch.
DES-3526:admin#create 802.1x guest_vlan Trinity
Command: create 802.1x guest_vlan Trinity
Success.
DES-3526:admin#
config 802.1x guest_vlan ports
Purpose Used to configure ports for a pre-existing 802.1x guest VLAN.
Syntax
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
Description
The config 802.1x guest_vlan ports command is used to configure ports to
be enabled or disabled for the 802.1x guest VLAN.
Parameters
<portlist> - Specify a port or range of ports to be configured for the 802.1x