Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
178
config 802.1x init
Description
The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC
addresses operating from a specified range of ports.
Parameters
port_based – This instructs the Switch to initialize 802.1x functions
based only on the port number. Ports approved for initialization can
then be specified.
mac_based − This instructs the Switch to initialize 802.1x functions
based only on the MAC address. MAC addresses approved for
initialization can then be specified.
ports <portlist> − Specifies a port or range of ports to be configured.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be initialized.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To initialize the authentication state machine of all ports:
DES-3526:admin# config 802.1x init
port_based ports all
Command: config 802.1x init port_based ports
all
Success.
DES-3526:admin#
config 802.1x reauth
Purpose Used to configure the 802.1x re-authentication feature of the Switch.
Syntax
config 802.1x reauth {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description
The config 802.1x reauth command is used to re-authenticate a
previously authenticated device based on port number.
Parameters
port_based – This instructs the Switch to re-authorize 802.1x functions
based only on the port number. Ports approved for re-authorization
can then be specified.
mac_based − This instructs the Switch to re-authorize 802.1x functions
based only on the MAC address. MAC addresses approved for re-
authorization can then be specified.
ports <portlist> − Specifies a port or range of ports to be re-authorized.
all − Specifies all of the ports on the Switch.
mac_address <macaddr> - Enter the MAC address to be re-
authorized.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To configure 802.1x reauthentication for ports 1-18:
DES-3526:admin#config 802.1x reauth port_based ports
1-18
Command: config 802.1x reauth port_based ports 1-18