Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
218
config time_zone
Purpose Used to determine the time zone used in order to adjust the system
clock.
Syntax
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
Description This will adjust system clock settings according to the time zone.
Time zone settings will adjust SNTP information accordingly.
Parameters
operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour – Select the number of hours different from GMT.
min – Select the number of minutes difference added or subtracted
to adjust the time zone.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To configure time zone settings:
DES-3526:admin#
config time_zone operator + hour 2 min
30
Command: config time_zone operator + hour 2 min 30
Success.
DES-3526:admin#
config dst
Purpose Used to enable and configure time adjustments to allow for the use of
Daylight Savings Time (DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day
<start_day sun-sat> | s_mth <start_mth 1-12> | s_time start_time
hh:mm> | e_week <end_week 1-4,last> | e_day <end_day sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth
1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
Description DST can be enabled and configured using this command. When enabled this
will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time
set using SNTP service.