Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
269
When a CS becomes a MS, it automatically becomes a member of the first SNMP community (include read/write and read only)
to which the CS belongs. However if a MS has its own IP address, it can belong to SNMP communities to which other switches in
the group, including the CS, do not belong.
The Upgrade to v1.6
To better improve SIM management, the xStack DES-3500 series switches have been upgraded to version 1.6 in this release.
Many improvements have been made, including:
The Commander Switch (CS) now has the capability to automatically rediscover member switches that have left the SIM group,
either through a reboot or web malfunction. This feature is accomplished through the use of Discover packets and Maintain
packets that previously set SIM members will emit after a reboot. Once a MS has had its MAC address and password saved to the
CS’s database, if a reboot occurs in the MS, the CS will keep this MS information in its database and when a MS has been
rediscovered, it will add the MS back into the SIM tree automatically. No configuration will be necessary to rediscover these
switches. There are some instances where pre-saved MS switches cannot be rediscovered. For example, if the Switch is still
powered down, if it has become the member of another group, or if it has been configured to be a Commander Switch, the
rediscovery process cannot occur.
This version will support multiple switch upload and downloads for firmware, configuration files and log files, as follows:
•
Firmware – The switch now supports multiple MS firmware downloads from a TFTP server.
•
Configuration Files – This switch now supports multiple downloading and uploading of configuration files both to (for
configuration restoration) and from (for configuration backup) MS’s, using a TFTP server..
•
Log – The switch now supports uploading multiple MS log files to a TFTP server.
NOTE: For more details regarding improvements made in SIMv1.6, please refer to the
White Paper located on the D-Link website.
The SIM commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
enable sim
disable sim
show sim {[candidates {<candidate_id 1-32>} | members {<member_id 1-32> } | group
{commander_mac <macaddr>}] | neighbor show ssl certificate]}
reconfig {member_id <value 1-32> | exit}
config sim_group [add <candidate_id 1-32> {<password>} | delete <member_id 1-32>]
config sim [{[commander {group_name <groupname 64> | candidate] | dp_interval <sec
30-90> | hold_time <sec 100-255>}
download sim_ms [firmware | configuration] <ipaddr> <path_filename> {members <mslist> | all}
upload sim_ms [configuration] <ipaddr> <path_filename> <member_id 1-32>
Each command is listed, in detail, in the following sections.