Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
128
create address_binding ip_mac ipaddress
Purpose Used to create an IP-MAC Binding entry.
Syntax
create address_binding ip_mac ipaddress <ipaddr> mac_address
<macaddr> {ports [<portlist> | all] | mode {arp | acl]}
Description This command will create an IP-MAC Binding entry.
Parameters
<ipaddr> The IP address of the device where the IP-MAC binding is
made.
<macaddr> The MAC address of the device where the IP-MAC binding
is made.
<portlist> - Specifies a port or range of ports to be configured for
address binding.
all – Specifies that all ports on the switch will be configured for address
binding.
mode – The user may set the mode for this IP-MAC binding settings by
choosing one of the following:
arp - Choosing this selection will set a normal IP-MAC Binding entry
for the IP address and MAC address entered.
acl - Choosing this entry will allow only packets from the source IP-
MAC binding entry created here. All other packets with a different
IP address will be discarded by the Switch. This mode can only
be used if the ACL Mode has been enabled in the IP-MAC
Binding Ports window as seen previously.
Restrictions User Account Command Level – Administrator and Operator.
Example usage:
To create address binding on the Switch:
DES-3526:admin#create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04
Success.
DES-3526:admin#
To create address binding on the Switch for ACL mode:
DES-3526: admin#create address_binding ip_mac ipaddress
10.1.1.3 mac_address 00-00-00-00-00-04 mode acl
Command: create address_binding ip_mac ipaddress 10.1.1.3
mac_address 00-00-00-00-00-04 mode acl
Success.
DES-3526:admin#
Once the ACL mode has been created and enabled (without previously created access profiles), the access profile table will look
like this: