Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
134
enable address_binding acl_mode
Purpose Used to enable the ACL mode for an IP-MAC binding entry.
Syntax
enable address_binding acl_mode
Description
This command, along with the disable address_binding acl_mode
will enable and disable the ACL mode for IP-MAC binding on the
Switch, without altering previously set configurations. When
enabled, the Switch will automatically create two ACL packet content
mask entries that can be viewed using the show access_profile
command. These two ACL entries will aid the user in processing
certain IP-MAC binding entries created.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this
command. The ACL entries created when this command is enabled,
can only be automatically installed if the Access Profile table has two
entries available of the possible 9 entries allowed. These access
profile entries can only be deleted using the disable
address_binding acl_mode and not though the delete
access_profile profile_id command. Also, the show config
command will not display the commands for creating the IP-MAC
ACL mode access profile entries.
Example usage:
To enable IP-MAC Binding ACL mode on the Switch:
DES-3526:admin#enable address_binding
acl_mode
Command: enable address_binding acl_mode
Success.
DES-3526:admin#
disable address_binding acl_mode
Purpose Used to disable the ACL mode for an IP-MAC binding entry.
Syntax
disable address_binding acl_mode
Description
This command, along with the enable address_binding acl_mode
will enable and disable the ACL mode for IP-MAC binding on the
Switch, without altering previously set configurations. When
disabled, the Switch will automatically delete two previously created
ACL packet content mask entries that can be viewed using the show
access_profile command.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this
command. The ACL entries created when this command is enabled,
can only be automatically installed if the Access Profile table has two
entries available of the possible 9 entries allowed. These access
profile entries can only be deleted using the disable
address_binding acl_mode and NOT though the delete
access_profile profile_id command. Also, the show config
command will not display the commands for creating the IP-MAC
ACL mode access profile entries.
Example usage: