Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
16
enable telnet
Parameters
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The “well-known” TCP port for
the Telnet protocol is 23.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To enable Telnet and configure port number:
DES-3526:admin#enable telnet 23
Command: enable telnet 23
Success.
DES-3526:admin#
disable telnet
Purpose Used to disable the Telnet protocol on the Switch.
Syntax
disable telnet
Description This command is used to disable the Telnet protocol on the Switch.
Parameters None.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To disable the Telnet protocol on the Switch:
DES-3526:admin#disable telnet
Command: disable telnet
Success.
DES-3526:admin#
telnet
Purpose Used to Telnet another device on the network.
Syntax
telnet <ipaddr> {tcp_port <value 0-65535>}
Description This command is used to connect to another device’s management
through Telnet.
Parameters
<ipaddr> - Enter the IP address of the device to connect through,
using Telnet.
tcp_port <value 0-65535> - Enter the TCP port number used to
connect through. The common TCP port number for telnet is 23.
Restrictions Only Administrator and Operator-level users can issue this
command.
Example usage:
To connect to a device through telnet with a IP address of 10.53.13.99: