Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
55
DES-3526:admin#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DES-3526:admin#
DES-3526:admin##
------------------------------------------------------------------------------------
DES-3526:admin## DES-3526 Configuration
DES-3526:admin##
DES-3526:admin## Firmware: Build 5.01-B47
DES-3526:admin## Copyright(C) 2000-2004 D-Link Corporation. All rights reserved.
DES-3526:admin##--------------------------------------------------------------------
DES-3526:admin#
DES-3526:admin#
DES-3526:admin## BASIC
DES-3526:admin#
DES-3526:admin#config serial_port baud_rate 9600 auto_logout 10_minutes
Command: config serial_port baud_rate 9600 auto_logout 10_minutes
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message “End of configuration file for DES-3526” appears followed by the
command prompt.
DES-3526:admin#disable authen_policy
Command: disable authen_policy
Success.
DES-3526:admin#
DES-3526:admin##---------------------------------------------------
DES-3526:admin## End of configuration file for DES-3526
DES-3526:admin##---------------------------------------------------
DES-3526:admin#
config firmware image_id
Purpose Used to configure the firmware section as a boot up section, or to
delete the firmware section
Syntax
config firmware image_id <value 1-n> [delete | boot_up]
Description This command is used to configure the firmware section. The user
may choose to remove the firmware section or use it as a boot up
section.
Parameters
image_id – Specifies the working section. The Switch can hold two
firmware versions for the user to select from, which are specified by
image ID.
delete – Entering this parameter will delete the specified firmware
section.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section.