Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
190
config access_profile
command. Priority is set relative to other profiles where the lowest profile ID has the highest
priority. The user may enter a profile ID number between 1 – 255, yet, remember only 9 access
profiles can be created on the Switch.
add access_id <value 1-65535> − Adds an additional rule to the above specified access
profile. The value is used to index the rule created. For information on number of rules
that can be created for a given port, lease see the introduction to this chapter.
ethernet − Specifies that the Switch will look only into the layer 2 part of each packet.
vlan <vlan_name 32> − Specifies that the access profile will apply to only to this VLAN.
source_mac <macaddr> − Specifies that the access profile will apply to only packets with this
source MAC address.
destination_mac <macaddr> − Specifies that the access profile will apply to only packets with
this destination MAC address.
802.1p <value 0-7> − Specifies that the access profile will apply only to packets with this
802.1p priority value.
ethernet_type <hex 0x0-0xffff> − Specifies that the access profile will apply only to packets
with this hexadecimal 802.1Q Ethernet type value in the packet header.