Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
284
config lldp tx_delay
Purpose Used to change the minimum time (delay-interval) of any LLDP port. It
will delay advertising successive LLDP advertisements due to a change
in LLDP MIB content. The tx_delay defines the minimum interval
between the sending of LLDP messages due to constant changes of MIB
content.
Syntax
config lldp tx_delay < sec 1–8192 >
Description The LLDP message_tx_interval (transmit interval) must be greater than
or equal to (4 x tx_delay interval).
Parameters
tx_delay - The range is from 1 second to 8192 seconds. The default
setting 2 seconds.
NOTE: txDelay should be less than or equal to 0.25 * msgTxInterval
Restrictions Only Administrator or Operator – level users can issue this command.
Example usage:
To configure the delay-interval interval:
DES-3526:admin#config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DES-3526:admin#
config lldp reinit_delay
Purpose Change the minimum time of reinitialization delay interval.
Syntax
config lldp reinit_delay < sec 1 – 10 >
Description An re-enabled LLDP port will wait for reinit_delay after last disable
command before reinitializing
Parameters reinit_delay - The range is from 1 second to 10 seconds. The default
setting 2 seconds.
Restrictions Only Administrator or Operator – level users can issue this command.
Example usage:
To change the re-initialization delay interval:
DES-3526:admin#config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DES-3526:admin#