Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
26
Command: config ports 1-3 speed 10_full learning enable
state enable
Success.
DES-3526:admin#
show ports
Purpose Used to display the current configuration of a range of ports.
Syntax
show ports [<portlist>] {description | err_disabled}
Description This command is used to display the current configuration of a
range of ports.
Parameters
<portlist> − Specifies a port or range of ports to be displayed.
{description} – Adding this parameter to the show ports command
indicates that a previously entered port description will be included
in the display.
{err_disabled} – Use this to list disabled ports including connection
status and reason for being disabled.
Restrictions None.
Example usage:
To display the configuration of all ports on a standalone switch:
DES-3526:admin#show ports
Command: show ports
Port State/ Settings Connection Address Trap
MDIX Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning State
----- ---------- --------------------- --------------------- -------- --------
1 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
2 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
3 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
4 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
5 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
6 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
7 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
8 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
9 Enabled Auto/Disabled 100M/Full/None Enabled Enabled
Auto
10 Enabled Auto/Disabled Link Down Enabled Enabled
Auto
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh