Filter
Top Products
DES-3500 Layer 2 Fast Ethernet Switch CLI Reference Manual
184
25
ACCESS CONTROL LIST (ACL) COMMANDS
The DES-3500 implements Access Control Lists that enable the Switch to deny network access to specific devices or device
groups based on IP settings and MAC address.
The access profile commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Note: The ACL command set has been changed for the Release III firmware. In particular, note the
different role of the profile_id and access_id parameters. The new treatment has changed some of
the command parameters as well.
Command Parameters
create access_profile
[ethernet {vlan | source_mac <macmask> | destination_mac <macmask> | 802.1p |
ethernet_type} ip {vlan | source_ip_mask <netmask> | destination_ip_mask <netmask> |
dscp | [icmp {type | code} | igmp {type} | tcp {src_port_mask <hex 0x0-0xffff> |
dst_port_mask <hex 0x0-0xffff> | flag_mask [all | {urg | ack | psh | rst | syn | fin}]} | udp
{src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff>} | protocol_id_mask <hex
0x0 - 0xFF> {user_define_mask <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>
<hex 0x0-0xffffffff> <hex 0x0-0xffffffff>}]} | packet_content_mask {offset_0-15
<hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> |
offset_16-31 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> |
offset_32-47 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> |
offset_48-63 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> |
offset_64-79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>}]
[profile_id <value 1-255>]
delete access_profile [profile_id <value 1-255> | all]
config access_profile profile_id <value 1-255> [add access_id <value 1-65535> [ethernet {vlan <vlan_name 32> |
source_mac <macaddr> | destination_mac <macaddr> | 802.1p <value 0-7> | ethernet_type
<hex 0x0-0xffff>} | ip {vlan <vlan_name 32> | source_ip <ipaddr> | destination_ip <ipaddr> |
dscp <value 0-63> | [icmp {type <value 0-255> code <value 0-255>} | igmp {type <value 0-
255>} | tcp {src_port <value 0-65535> | dst_port <value 0-65535> | flag_mask [all | {urg |
ack | psh | rst | syn | fin} | udp {src_port <value 0-65535> | dst_port <value 0-65535>} |
protocol_id <value 0 - 255> {user_define <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-
0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>}]} | packet_content_mask {offset_0-15 <hex
0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | offset_16-31 <hex
0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | offset_32-47 <hex
0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | offset_48-63 <hex
0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> | offset_64-79 <hex
0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>}]
port <portlist> [permit {priority <value 0-7> {replace_priority} | replace_dscp_with <value 0-
63>} | deny] {time_range <range_name 32>} | delete access_id <value 1-65535>]
show access_profile {profile_id <value 1-255> {access_id <value 1-65535>}}
enable
cpu_interface_filtering
disable
cpu_interface_filtering
create cpu
access_profile
profile_id
<value 1-5> [ethernet {vlan | source_mac <macmask> | destination_mac <macmask> |
802.1p | ethernet_type} | ip {vlan | source_ip_mask <netmask> |
destination_ip_mask <netmask> | dscp | [icmp {type | code} | igmp {type} | tcp
{src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff> | flag_mask [all | {urg |
ack | psh | rst | syn | fin}]} | udp {src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-
0xffff>} | protocol_id_mask {<hex 0x0-0xff> {user_define_mask <hex 0x0-0xffffffff>}]} |
packet_content_mask {offset 0-15 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>