Filter
Top Products
104
Default Setting
None
Command Mode
Vlan Database
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval on a particular VLAN. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report
from a particular group on a particular interface, which is participating in the VLAN, before
deleting the interface from the entry. This value must be greater than IGMP Maximum
Response time value. The range is 2 to 3600 seconds.
Syntax
set igmp groupmembership-interval <1-3965> <2-3600>
no set igmp groupmembershipinterval <1-3965>
<1-3965> - VLAN ID (Range: 1 – 3965).
<2-3600> - The range of group membership interval time is 2 to 3600 seconds.
no - This command sets the IGMP Group Membership Interval time on a particular VLAN to the default
value.
Default Setting
260
Command Mode
Vlan Database
set igmp maxresponse
This command sets the IGMP Maximum Response time on a particular VLAN. The Maximum
Response time is the amount of time in seconds that a switch will wait after sending a query
on an interface, which is participating in the VLAN, because it did not receive a report for a
particular group in that interface. This value must be less than the IGMP Query Interval time
value.