Filter
Top Products
142
Syntax
show snmp
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Community Name: The community string to which this entry grants access. A valid entry is a
case-sensitive alphanumeric string of up to 16 characters. Each row of this table must contain a unique
community name.
Client IP Address: An IP address (or portion thereof) from which this device will accept SNMP packets
with the associated community. The requesting entity's IP address is ANDed with the Subnet Mask before
being compared to the IP Address. Note: that if the Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0
matches all IP addresses. The default value is 0.0.0.0
Client IP Mask: A mask to be ANDed with the requesting entity's IP address before comparison with IP
Address. If the result matches with the IP Address then the address is an authenticated IP address. For
example, if the IP Address = 9.47.128.0 and the corresponding Subnet Mask = 255.255.255.0, a range of
incoming IP addresses would match. That is, the incoming IP Address could equal 9.47.128.0 -
9.47.128.255. The default value is 0.0.0.0.
Access Mode: The access level for this community string.
Status: The status of this community access entry.
5.3.4.2 show trapflags
This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is
detected, the switch's SNMP agent sends the trap to all enabled trap receivers. The switch
does not have to be reset to implement the changes. Cold and warm start traps are always
generated and cannot be disabled.
Syntax
show trapflags
Default Setting
None
Command Mode
Privileged Exec
Display Message