Filter
Top Products
357
6.6 Routing Information Protocol (RIP)
Commands
6.6.1 Show Commands
6.6.1.1 show ip rip
This command displays information relevant to the RIP router.
Syntax
show ip rip
Default Setting
None
Command Mode
Privileged Exec
Display Message
RIP Admin Mode: Select enable or disable from the pulldown menu. If you select enable RIP will be
enabled for the switch. The default is disabled.
Split Horizon Mode: Select none, simple or poison reverse from the pulldown menu. Split horizon is a
technique for avoiding problems caused by including routes in updates sent to the router from which the
route was originally learned. The options are: None - no special processing for this case. Simple - a route
will not be included in updates sent to the router from which it was learned. Poisoned reverse - a route will
be included in updates sent to the router from which it was learned, but the metric will be set to infinity. The
default is simple
Auto Summary Mode: Select enable or disable from the pulldown menu. If you select enable groups of
adjacent routes will be summarized into single entries, in order to reduce the total number of entries. The
default is enabled.
Host Routes Accept Mode: Select enable or disable from the pulldown menu. If you select enable the
router will be accept host routes. The default is enabled.
Global Route Changes: The number of route changes made to the IP Route Database by RIP. This does
not include the refresh of a route's age.
Global queries: The number of responses sent to RIP queries from other systems. Default Metric Sets a
default for the metric of redistributed routes. This field displays the default metric if one has already been
set or blank if not configured earlier. The valid values are (1 to 15).
Default Metric: Sets a default for the metric of redistributed routes. This field displays the default metric if
one has already been set or blank if not configured earlier. The valid values are (1 to 15).
Default Route Advertise: The default route.