Filter
Top Products
404
Syntax
mrinfo [<ipaddr>]
<ipaddr> - the IP address of the multicast capable router.
Default Setting
None
Command Mode
Privileged Exec
7.3.2.7 mstat
This command is used to find the packet rate and loss information path from a source to a
receiver (unicast router id of the host running mstat). The results of this command will be
available in the results bufferpool which can be displayed by using "show mstat". If a debug
command is already in progress, a message is displayed and the new request fails.
The <source> is the IP Address of the remote multicast-capable source. The [<receiver>] is
the IP address of the receiver. The default value is the IP address of system at which the
command is issued. The [<group>] is a multicast address of the group to be displayed.
Default value is 224.2.0.1
Syntax
mstat <source> [<group>] [<receiver>]
< source > - the IP address of the multicast data source.
<group> - the multicast address of the group to be traced. If you leave this field blank, the multicast
address 224.2.0.1 will be used. Valid addresses are 224.0.0.0 through 239.255.255.255.
< receiver > - the IP address of the host to which the mstat response will be sent by the last hop router.
Default Setting
None
Command Mode
Privileged Exec