Filter
Top Products
505
8.2.2.7 Managing Spanning Tree
Configuring Switch Spanning Tree Configuration Page
Configurable Data
Spanning Tree Mode - Specifies whether spanning tree operation is enabled on the switch. Value is
enabled or disabled
Force Protocol Version - Specifies the Force Protocol Version parameter for the switch. The options
are IEEE 802.1d, IEEE 802.1w, and IEEE 802.1s The default value is IEEE 802.1w.
Configuration Name- Identifier used to identify the configuration currently being used. It may be up to
32 alphanumeric characters
Configuration Revision Level - Identifier used to identify the configuration currently being used. The
values allowed are between 0 and 65535. The default value is 0.
Non-Configurable Data
Configuration digest key - Identifier used to identify the configuration currently being used.
MST Table - Table consisting of the MST instances (including the CST) and the corresponding VLAN
IDs associated with each of them.
VID Table - Table consisting of the VLAN IDs and the corresponding FID associated with each of them.
FID Table - Table consisting of the FIDs and the corresponding VLAN IDs associated with each of them.
Command Buttons
Submit - Applies the new configuration and causes the changes to take effect. These changes will not
be retained across a power cycle unless a save configuration is performed.
Refresh - Refreshes the screen with most recent data.
Configuring Spanning Tree CST Configuration Page
Configurable Data
Bridge Priority - Specifies the bridge priority for the Common and Internal Spanning tree (CST). The
value lies between 0 and 61440. It is set in multiples of 4096. For example, if you set the priority to any
value between 0 and 4095, it will be set to 0. If it is tried to be set to any value between 4096 and
(2*4096-1) it will be set to 4096 and so on. The default priority is 32768.