Filter
Top Products
582
sum of (retransmit times timeout) for all configured servers. If the RADIUS request was generated by a
user login attempt, all user interfaces will be blocked until the RADIUS application returns a response.
Timeout Duration (secs) - The timeout value, in seconds, for request retransmissions. The valid range
is 1 - 30. Consideration to maximum delay time should be given when configuring RADIUS
maxretransmit and RADIUS timeout. If multiple RADIUS servers are configured, the max retransmit
value on each will be exhausted before the next server is attempted. A retransmit will not occur until the
configured timeout value on that server has passed without a response from the RADIUS server.
Therefore, the maximum delay in receiving a response from the RADIUS application equals the sum of
(retransmit times timeout) for all configured servers. If the RADIUS request was generated by a user
login attempt, all user interfaces will be blocked until the RADIUS application returns a response.
Accounting Mode - Selects if the RADIUS accounting mode is enabled or disabled.
Non-Configurable Data
Current Server IP Address - The IP address of the current server. This field is blank if no servers are
configured.
Number of Configured Servers - The number of RADIUS servers that have been configured. This
value will be in the range of 0 and 3.
Command Buttons
Submit - Sends the updated screen to the switch and causes the changes to take effect on the switch
but these changes will not be retained across a power cycle unless a save is performed.
Refresh - Update the information on the page.
Viewing Radius Statistics Page
Non-Configurable Data
Invalid Server Addresses - The number of RADIUS Access-Response packets received from unknown
addresses.
Command Buttons
Refresh - Update the information on the page.