Filter
Top Products
432
Baud Rate (bps) - Select the default baud rate for the serial port connection from the pull-down menu.
You may choose from 1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200 baud. The factory
default is 9600 baud.
Password Threshold - When the logon attempt threshold is reached on the console port, the system
interface becomes silent for a specified amount of time before allowing the next logon attempt. (Use the
silent time command to set this interval.) When this threshold is reached for Telnet, the Telnet logon
interface closes. The default value is 3.
Silent Time (Sec) - Use this command to set the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts exceeds the threshold set by the password
threshold command. The default value is 0.
Non-Configurable Data
Character Size (bits) - The number of bits in a character. This is always 8.
Flow Control - Whether hardware flow control is enabled or disabled. It is always disabled.
Parity - The parity method used on the serial port. It is always None.
Stop Bits - The number of stop bits per character. It is always 1.
Command Buttons
Submit - Update the switch with the values on the screen. If you want the switch to retain the new values
across a power cycle you must perform a save.
Defining User Accounts Page
By default, two user accounts exist:
admin, with 'Read/Write' privileges
guest, with 'Read Only' privileges
By default, both of these accounts have blank passwords. The names are not case sensitive.
If you logon with a user account with 'Read/Write' privileges (that is, as admin) you can use
the User Accounts screen to assign passwords and set security parameters for the default
accounts, and to add and delete accounts (other than admin) up to the maximum of six. Only
a user with 'Read/Write' privileges may alter data on this screen, and only one account may
be created with 'Read/Write' privileges.
Selection Criteria