Filter
Top Products
624
Source Filter Mode - The source filter mode (Include/Exclude/NA) for the specified group on this
interface.
Source Hosts - This parameter shows source addresses which are members of this multicast address.
Expiry Time - This parameter shows expiry time interval against each source address which are
members of this multicast group. This is the amount of time after which the specified source entry is aged
out.
8.2.6.3 Defining Multicast Configuration
Configuring Multicast Global Configuration Page
Selection Criteria
Admin Mode - Select enable or disable to set the administrative status of Multicast Forwarding in the
router. The default is disabled.
Non-Configurable Data
Protocol State - The operational state of the multicast forwarding module.
Table Maximum Entry Count - The maximum number of entries in the IP Multicast routing table.
Number Of Packets For Which Source Not Found - The number of multicast packets that were
supposed to be routed but which failed the RPF check.
Number Of Packets For Which Group Not Found - The number of multicast packets that were
supposed to be routed but for which no multicast route was found.
Protocol - The multicast routing protocol presently activated on the router, if any.
Table Entry Count - The number of multicast route entries currently present in the Multicast route table.
Table Highest Entry Count - The highest number of multicast route entries that have been present in
the Multicast route table.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect immediately.
These changes will not be retained across a power cycle unless a save is performed.