Filter
Top Products
393
no - This command resets the number of Queries sent out on startup, separated by the Startup Query
Interval on the interface to the default value.
Default Setting
2
Command Mode
Interface Config
7.2.2.9 ip igmp startup-query-interval
This command sets the interval between General Queries sent by a Querier on startup on the
interface. The time interval value is in seconds.
Syntax
ip igmp startup-query-interval <1-300>
no ip igmp startup-query-interval
<1-300> - The range for <1-300> is 1 to 300 seconds.
no - This command resets the interval between General Queries sent by a Querier on startup on the
interface to the default value.
Default Setting
31
Command Mode
Interface Config
7.3 Multicast Commands
7.3.1 Show Commands
7.3.1.1 show ip mcast
This command displays the system-wide multicast information