Filter
Top Products
Performing preventive maintenance
You should replace certain parts when the PERFORM PRINTER MAINTENANCE message
appears on the printer control panel display. This will help ensure that your printer maintains
optimum performance.
The maintenance message will appear every 200,000 pages. The message can be
temporarily cleared for approximately 10,000 pages by using the CLEAR MAINTENANCE
MESSAGE item on the Resets submenu. (See
Resets submenu.) To check the number of
pages the printer has printed since new maintenance-kit components were installed, print
either a configuration page or a supplies status page. (See
Configuration page or Supplies
status page for details.)
To order the printer maintenance kit, see
Part numbers. The kit includes:
● fuser
● rollers (transfer, pickup, and feed)
● installation instructions
NOTE
The printer maintenance kit is a consumable item and is not covered under the original
printer warranty or under most extended warranties.
After a maintenance kit is installed, the maintenance-kit counter must be reset.
To reset the maintenance-kit counter
1. Turn the printer power off and then on.
2.
When XXX appears on the control-panel display, press and hold down
(S
ELECT
button). Continue holding down (S
ELECT
button) until all three printer control panel
lights flash once, and then stay on. This might take up to 10 seconds.
3.
Release
(S
ELECT
button) and press (U
P
button) to scroll to NEW MAINTENANCE KIT.
4.
Press
(S
ELECT
button) to reset the maintenance-kit counter.
NOTE
Perform this procedure only after a maintenance kit has been installed. Do not use this
procedure to temporarily clear the PERFORM PRINTER MAINTENANCE message.
ENWW Performing preventive maintenance 115