Filter
Top Products
Cartridge out
The printer has two options for this menu item.
● Select CONTINUE to allow the printer to continue printing. A REPLACE CARTRIDGE
warning message appears until the print cartridge is replaced. Printing in this mode can
continue only for a specific number of pages. After that, the printer stops printing until
you replace the empty print cartridge. This is the default setting.
● Select STOP if you want the printer to stop printing until the empty print cartridge is
replaced.
To set the cartridge-out response
1. Press M
ENU
to open the menus.
2.
Press
(D
OWN
button) to highlight CONFIGURE DEVICE.
3.
Press
(S
ELECT
button) to select CONFIGURE DEVICE.
4.
Press
(D
OWN
button) to highlight SYSTEM SETUP.
5.
Press
(S
ELECT
button) to select SYSTEM SETUP.
6.
Press
(D
OWN
button) to highlight CARTRIDGE OUT.
7.
Press
(S
ELECT
button) to select CARTRIDGE OUT.
8.
Press
(U
P
button) or (D
OWN
button) to select the appropriate setting.
9.
Press
(S
ELECT
button) to set the selection.
10. Press M
ENU
to exit the menu.
Jam recovery
Use this option to configure the printer response to jams, including how the printer handles
the pages involved. AUTO is the default value.
● AUTO. The printer automatically turns jam recovery on when sufficient memory is
available.
● ON. The printer reprints any page that is involved in a jam. Additional memory is
allocated to store the last few pages that were printed, and this might cause overall
printer performance to suffer.
● OFF. The printer does not reprint any page that was involved in a jam. Because no
memory is used to store the most recent pages, overall printer performance might be
optimized.
ENWW Control panel 23