Filter
Top Products
ENWW Configuring network options 117
To set the ring and beep volumes
z Embedded Web server (network connection)
Open the embedded Web server and click the Settings tab. Click Maintenance in the left
pane, click Device Settings tab, and use the Ring/Beep Volume option.
z Control panel
Press M
ENU, open the MAINTENANCE menu, and use the Ring and beep volume option.
Setting the automatic paper-type sensor
You can set the all-in-one to select the print settings that are appropriate for the media that is
loaded. When you turn on this feature, the all-in-one detects the type of media (such as plain
paper or transparencies) and automatically selects the media type and print quality that are
most suitable for the job.
To set the automatic paper-type sensor
z Control panel
Press M
ENU and open the PRINTER menu. Select the Configure tray option to open the
TRAY submenu, and use the Automatic media type sense option.
Configuring network options
This section contains information about the following topics.
z Configuring the I/O timeout
z Configuring the network parameters
Configuring the I/O timeout
You can set the length of time that the all-in-one waits for remaining data for a print job. If that
time is exceeded, the all-in-one prints the print job.
To configure I/O timeout
z Control panel
Press M
ENU, open the NETWK & I/O menu, and use the I/O timeout option.
Configuring the network parameters
If the all-in-one is connected to a network with an HP Jetdirect print server, you can configure
the following protocols for the all-in-one. See the HP Jetdirect Administrator’s Guide on
Starter CD 1 for more information about these options. Check the Configuration page for
current settings (see Configuration page).
z DLC/LLC
z IPX/SPX
z TCP/IP
z AppleTalk