Filter
Top Products
26 2 - Installing accessories ENWW
Installing tray 2
Tray 2 comes with the HP Officejet 9120 all-in-one and HP Officejet 9130 all-in-one. It is an
optional accessory for the HP Officejet 9110 all-in-one. Tray 2 holds up to 250 sheets of plain
paper. You can replace the tray with a 500-sheet tray. See Ordering HP accessories and
supplies for information about ordering accessories.
To install tray 2
1 Unpack the tray, remove the packing tape and materials, and move the tray to the
prepared location.
2 Press (P
OWER) to turn off the all-in-one.
3 Unplug the power cord.
4 If you are installing the tray on an HP Officejet 9110 all-in-one, remove the tray ramp.
Open the print-carriage access door, use a Phillips screwdriver to remove the two screws
that hold the tray ramp in place, and then slide the tray ramp out of the all-in-one.
5 Set the all-in-one on top of the tray.
WARNING! Be careful to keep your fingers and hands clear of the bottom of the all-in-one.
6 Plug the power cord in and press (P
OWER) to turn on the all-in-one.
7 See Turning on accessories in the printer driver for information about turning on tray 2 in
the printer driver.