Filter
Top Products
Use OpenType or TrueType fonts to ensure that the HP All-in-One is able to print
smooth fonts. When selecting a font, look for the TrueType or OpenType icon.
The printout has a horizontal band of distortion near the bottom of the page
Cause: Your image has light blue, gray, or brown hues that print near the bottom
of the page.
Solution: Load high-quality paper in the input tray and print the image with a high
print quality setting, such as Best, Maximum dpi, or High Resolution. Always make
sure the paper you are printing on is flat. For best results when printing images, use
HP Premium Plus Photo Paper.
If the problem persists, use the software you installed with the HP All-in-One or
another software application to rotate your image 180 degrees so that the light blue,
gray, or brown hues in your image do not print at the bottom of the page. Print the
image using six-ink printing. To do so, install the photo print cartridge in place of the
black print cartridge. With the photo print cartridge and the tri-color print cartridge
installed, you have a six-ink system, which provides enhanced quality photos.
For more information, see:
•“
Information on paper” on page 93
•“
Troubleshoot print cartridges” on page 95
Colors run into each other on the printout
Cause: The print or copy quality setting is set too high for the type of paper loaded
in the HP All-in-One.
Solution: Check the quality setting. Use a lower quality setting to decrease the
amount of ink used for printing or copying.
For more information, see:
•“
Change the print speed or quality” on page 44
•“
Change copy speed or quality” on page 72
Cause: The paper type is not suitable for the HP All-in-One.
Solution: Use HP Premium Papers or any other paper type that is appropriate for
the HP All-in-One.
For more information, see:
“
Information on paper” on page 93
Cause: You are printing on the wrong side of the paper.
Chapter 13
114 Troubleshooting
Troubleshooting