Filter
Top Products
7. Use the front panel feed menu to feed enough additional media through the media feederto provide
two full turns on the take-up reel (Refer to
Perform a manual media feed).
8. At the rear of the printers, set the white media winding direction switch (1) to the OFF position.
9. Turn the take-up reel by hand (in the required direction—for inner or outer take-up) until two full turns
have been wound onto the reel.
10. Feed enough additional media through the media feeder to create a slack area (approximately 30 cm)
in the media sufficient to install the tension bar.
11. Mount the flanges on the tension bar, refer to
Tension bars.
12. Adjust the positions of the flanges (1) on the tension bar, on the take-up side, to the width of the media.
118 Chapter 3 How do I use dual media rolls? ENWW
How do I use dual media rolls?