Filter
Top Products
19. Adjust the media so that the marks (2) that you made earlier are aligned with the groove (1) in the
platen. If they do not align with platen groove at both sides, align either end first, and then while holding
the aligned side in place, pull the other side to adjust its position.
20. Lower the media load lever.
21. Adjust the media edge guards (1) so that they are correctly positioned at the edge of the media.
22. If you have not already done so, install the separator bar. Refer to Use the liner separator bar.
ENWW Double sided printing with a liner 163
How do I print with a liner