Filter
Top Products
4. To exit the parameter setup mode, scroll to the EXIT option and press the On/Off key to select YES.
5. Press the On/Off key on the heater front panel to confirm.
Connect to a computer
This section describes system configuration and cable connection procedures.
NOTE Before connecting or disconnecting the USB cable, turn the printer OFF.
Choose the system configuration
The following connections are possible.
1. Printer
2. USB interface
3. Printer server (RIP)
Connection procedure
CAUTION Make sure the USB cable is correctly routed to avoid contact with the media.
NOTE Before you connect the USB cable, you should ensure that the RIP is installed so that
the printer can be detected by your operating system. Refer to the instructions that came with
your RIP for installation instructions.
ENWW Connect to a computer 13
Introduction