Filter
Top Products
4. Put the rubber spacer A (1) on the flange spacer (2).
5. Engage the flange spacer and rubber spacer A (2) with the flange stopper and mount them both on
the on the scroller (1).
If the internal diameter of the media tube is too small to fully engage the flange spacer and rubber
spacer A (2), resulting in a large space between flange spacer and the edge of the media tube, use
the rubber spacer B (3) to fill this gap.
6. Temporarily install the media tube flanges (1) on the rubber spacers. You will adjust the position of
these later according to the actual media width.
7. At the rear of the printer, set the white media winding direction switch to the OFF position.
62 Chapter 2 How do I perform basic media operations? ENWW
How do I perform basic media
o
p
erations?