Filter
Top Products
Connect a USB cable as follows:
1. Disconnect the USB cable (2) from the rear of your printer if it is already connected.
2. Turn the printer off at the front panel.
3. Power off the printer using the power switch at the rear.
4. Connect a USB cable (2) to the USB connector (1) at the rear of the printer.
5. Use the cable clamps (4) provided, to secure the USB cable (2) to either side, according to the location
of the computer relative to the printer.
6. Connect a USB cable to the USB connector on your computer (3).
7. Power on the printer using the power switch at the rear.
8. Turn the printer on at the front panel.
9. On your computer, select the printer.
Turn the power on/off
WARNING! Only use a 200-240 V AC power supply voltage.
Be sure the printer is well-grounded. Failure to ground the printer may result in electrical shock,
fire, and susceptibility to electromagnetic interference.
CAUTION Always hold the power cord by the plug when connecting and disconnecting from
the power outlet. Never pull on the cord because this may damage it and create risk of fire and
electric shock.
14 Chapter 1 Introduction ENWW
Introduction