Filter
Top Products
NOTE The next operation will not start if the media is too tight.
If the operation finishes successfully, the printer returns to the online or offline state.
If it terminates unsuccessfully, an error message will be shown. If this occurs, retry the operation from
the step in this procedure where you raised the media load lever.
21. Set the “VACUUM” and “UNSTICK MODE” values with the front panel according to the type of media
you are using. Refer to
Unstick mode (UNSTICK MODE).
NOTE It is recommended to perform a normal printhead recovery before starting to print
on the back of the media. Refer to
Normal printhead recovery.
22. Print on the back of the media.
NOTE The output image from the RIP must be rotated 180º when using this method.
152 Chapter 4 How do I perform double-sided printing ENWW
How do I perform double-sided
p
rintin
g