Filter
Top Products
6. Slide the separator bar holder (2) onto the support bar (1) at the wiper end.
7. Secure the separator bar holder (4) with the two attachment screws (2) from the installation kit, and
push the rubber end cap (3) onto the end of the support bar (1).
8. Repeat the previous three steps, to install the separator bar holder at the cap end.
Install the separator bar
To use the separator bar.
1. Make sure the separator bar mounting assembly has been previously installed on your printer; install
it if necessary ( Refer to
Install the separator bar support assembly).
186 Chapter 5 How do I print with a liner ENWW
How do I print with a liner