HP (Hewlett-Packard) 10000s Printer User Manual


 
Turn on the printer
1. Turn off (position 0) the printer switch (1) on the rear of the printer, and plug one end of the supplied
power cable into the power socket (2) of the printer. Insert the other power plug of the cable into a
suitable electrical outlet.
WARNING! Avoid overloading the printer’s electrical outlet with multiple devices. Use only
the electrical cord supplied by HP with the printer. Do not damage, cut, or repair the power
cord. A damaged power cord causes a risk of fire and electric shock. Replace a damaged
power cord with an HP-approved power cord.
2. Turn on (position 1) the printer switch (1) on the rear of the printer (left hand side viewed from the rear
of the printer).
3. Press the POWER ON/OFF key (1) on the front panel.
ENWW Turn the power on/off 15
Introduction