Filter
Top Products
Feed side tension bar assembly
The tension bars screw into one another to make a total length of 266 cm if all four are used. The long
tension bar, with two male joints, must always be used, with or without additional medium and short tension
bars because it has male joints which are required for fitting flanges.
●
If the tension bar is going to be installed in the slack area of the media, use one or more tension bars
(3) to create a total length that is equivalent to half the width of the media and do not install the flanges
(1) and ESD contact ring (2).
●
If the tension bar is going to be installed in the tension bar guides, use the required tension bars to
create a total length that is equivalent to the width of the printer, install two standard flanges (1) at the
left end and an ESD contact ring (2) and another standard flange (1) at the right hand end.
Take-up side assembly method
The tension bars screw into one another to make a total length of 266 cm, if all four are used. The long
tension bar, with two male joints, must always be used, with or without additional medium and short tension
bars because it has male joints which are required for fitting flanges.
ENWW Tension bars 59
How do I perform basic media
o
p
erations?