Filter
Top Products
19. At the wiper end of the tension bar (1), adjust the take-up bar flange (3) position for the width of the
media, leaving a 2 mm gap, and lock it in position with the two O-rings (2).
20. At the capping end, adjust the take-up flange (1) on the tension bar (2) so it is positioned against the
edge of the media (without the fixing O-rings).
21. At the rear of the printer, set the white media winding direction switch (1) to the correct position for
the direction the media is to be taken-up, inner take-up (A) or outer take-up (B).
56 Chapter 2 How do I perform basic media operations? ENWW
How do I perform basic media
o
p
erations?