Filter
Top Products
Heater preset temperature by medium
The heater preset temperature for each media type is listed below. Preset the heater temperature according
to the media you use.
Medium Media type Front Print Rear Print mode
Glossy vinyl
chloride
Glossy 45°C 40°C 45°C 4-pass
bidirectional
Matte vinyl
chloride
Matte 45°C 40°C 45°C 4-pass
bidirectional
Banner Banner 45°C 40°C 45°C 4-pass
bidirectional
We recommend that the front heater, the print heater and the rear heater be set to lower than 50 °C, 45 °
C and 50 °C, respectively. When the print heater is set to higher than 45 °C, we recommend setting the
printhead motion mode to HIGHLIGHT.
NOTE When the print heater temperature is set too high, fixing of the ink on the media is
improved, but media wrinkle or mat print may be caused. Adjust heater temperature according
to the media type and environmental temperature.
When the print heater temperature is set to high, the printer may print at low speed to ensure
stable print quality.
Set the front/rear heater temperature 5 °C higher than the print heater temperature. Bad
temperature balance between the front/rear heater and print heater may cause the media to
wrinkle.
ENWW Heater temperature settings 303
Tell me about the heaters