Filter
Top Products
13. Mount the tension bar (1), in the slack area of the media, and adjust the take-up flanges to the width
of the media.
CAUTION Make sure you install the tension bar with the ESD flange at the left hand end
of the tension bar (viewed from the rear of the printer).
14. At the rear of the printer, set the white media winding direction switch (1) to the correct position for
the direction the media is to be taken-up, inner take-up (A) or outer take-up (B).
Dual media rolls take-up method 2
This procedure describes how to take-up two tarpaulin media rolls onto two separate media tubes.
NOTE Use media tubes with as closely matching internal diameters as possible because a small
difference in diameter greatly affects the take-up length of the media rolls causing abnormal
operation.
ENWW Use the take-up reel (dual media rolls) 119
How do I use dual media rolls?