Filter
Top Products
The printer's heaters
This section describes how to control the printer's heaters used for drying the printed media.
The heater's front panel
The heater's front panel is located on the front of the printer, on the left-hand side. The heater front panel
displays the settings for the Front, Print, and Rear heaters. It can also be used to control the temperature
settings.
1. The display screen, at the top of the panel, shows the target temperature and the current temperature
of each heater.
2. The three On/Off switches turn the three heaters on or off. The three pairs of
or keys can be used
to raise or lower the target temperatures of the respective heaters.
Defining heater parameters
1. On the heater front panel press the On/Off key, and the and keys at the same time to enter the
parameter setup mode.
2. Select a setup parameter using the and keys on the heater front panel and press the On/Off key
on the heater front panel to modify the setup item displayed.
3. Use the
and keys to select the value and press the On/Off key to confirm.
NOTE If you have selected an incorrect setup value, you can press the On/Off key again
to cancel the setting and repeat from step 2.
12 Chapter 1 Introduction ENWW
Introduction